Zooz Z-Wave Plus S2 On Off Wall Switch ZEN26 with New Simple Direct 3-Way and 4-Way (Works with Existing On Off Switches, No Add-Ons)

RELIABLE ON/OFF CONTROL: Turn your lights on and off remotely or automate them through Z-Wave. Hub required (sold separately), scroll down for compatibility. Voice control only available with Alexa-compatible Z-Wave hub (will NOT work directly with a smart speaker).

SIMPLE DIRECT 3-WAY & 4-WAY: Use it with existing on/off switches (NO dimmers) in your 3-way, 4-way, or 5-way set-up, even if load and line are not in the same box. No need for add-on switches, no need to rewire other boxes. Just put the Zooz in the box with power and neutral wires. Connection to power and NEUTRAL required (check your boxes before buying).

FASTER INSTALLATION: It takes half the time to install Zooz S2 switches in 3-way and 4-way set-ups than for any other Z-Wave solution. Intuitive wiring diagrams are printed in the manual (look for more on Zooz website) and if you need custom instructions, they’ll create them for you! IMPORTANT: Make sure ALL boxes match the wiring diagrams in the manual before installing the switch.

BONUS FEATURES: Z-Wave Plus signal repeater, instant status updates, adjustable LED indicator (now change LED modes straight from the switch paddle), on/off status recovery after power failure.

EXTRA SECURITY: Equipped with the new S2 security protocol. Z-Wave Plus and ETL certified for communication and safety standards compliance. Lifetime tech support.

, 0853478006261, 853478006261

    NOTE: Do NOT connect this switch to ceiling fans, motors, or home appliances
    NEUTRAL WIRE REQUIRED

      SPECIFICATIONS:

    • Model Number: ZEN26
    • Z-Wave Signal Frequency: 908.42 MHz
    • Power: 120 VAC, 60 Hz
    • Maximum Loads: 600 W Incandescent, 150 W LED’s, 8 A Resistive
    • Z-Wave Range: Up to 100 feet line of sight between the Wireless Controller and the closest Z-Wave receiver module
    • Operating Temperature: 32-104° F (0-40° C)
    • Installation and Use: Indoor only
    • Will it work with Alexa / Google Home?
      Amazon Echo and Google Home are not Z-Wave controllers so you will need a compatible Z-Wave hub to control this switch with your smart speaker.
      Alexa- and Google Home-compatible Z-Wave hubs include:

    • Fibaro Home Center Lite
    • Hubitat
    • SmartThings
    • VeraPlus
    • Wink

Leave a Reply