Makita 2 Pack – 4? Continuous Diamond Blades For 4?+ Grinders & Circular Saws – Precise Cutting For Tile, Porcelain & Stone – 5/8?, 20mm & 7/8? Arbors

2 Makita 4” CONTINUOUS Diamond Blades For 1” Depth Cutting into TILE, PORCELAIN & STONE Applications

4″ x .79 x 5/8-Inch Arbor, Optimized for Makita 4” & 4.5″ Angle Grinders & 4″+ Circular Saws and compatible with All 4” & 4.5″ Angle Grinders & Saws

CUT 3-4X MORE Tile, PORCELAIN, Stone than lower quality blades due to Makita’s Industry leading Diamonds and Premium Bond that provide the optimal cut-to-wear ratio, optimized for the best Cut Life, Cut Rate, Cut Precision, Power Demands & Heat Buildup in the industry

For Best Results, consider using Water to flush out debris and Extend Blade Life

PRECISELY & EASILY CUT Marble, Granite, Stone, Glass, Porcelain & Ceramic Tile, including Flagstone & PermaBase with Minimal Material Crack OR Shatter Risk

TURBO & SEGMENTED Steel blades are ideal for FASTER and LONG-LASTING Cuts in General Concrete & Non-Tile/Stone Masonry

AVOID BLADEWEAR Slow Downs with lower priced blades by relying on Makita’s proprietary matrix bond, allowing for fast, accurate and continuous cutting PERFORMANCE, PRECISION, LONGEVITY, STABILITY & INTEGRITY, cutting Longer, Faster and Reliably than other blades that may warp or prematurely wear

DESIGNED for Hard and Continuous use by professionals in construction, concrete fabrication, general maintenance, Tile, Granite, Stone & general industrial applications, these blades are Quality tested and laser welded for unsurpassed blade integrity, planned to outperform other blades in its class

Each blade is engineered to work at 15,300 RPM at a 1 Inch maximum cutting depth

A-95065, 0088381368919, 088381368919

Optimize your Tile, Ceramic & Porcelain work with this Makita 2 Pack Premium 4? Diamond Continuous Blades. Working at a 90-degree angle, perpendicular to the work surface, applying the proper amount of pressure to allow the cutting blade to do the work. For best results, consider not pushing too hard on the blade, which can cause the grinder to stall or kick back or give a less efficient cutting action, while also increasing the chances of slippage or loss of control of the tool, resulting in injury or damage and premature wear. Applying light to moderate pressure and consistent movement, along with intermittent water will provide the most efficient cut and minimize heat build-up causing warpage of the blade. Consider using light pressure and a consistent motion throughout the cut for the fastest cut-rate and prolonged wheel life. Excessive pressure through the cut causes increased friction and heat build-up, which can cause blade warpage and reduced wheel life. For demanding applications, higher amperage &/or torque angle grinders provide easier, long-lasting & efficient cuts.

Leave a Reply