PTE Wire Tracer & Circuit Tester -Tone Generator & Probe Kit – Find & Trace Wires & Cables, Test Circuit Continuity, Network Telephone Line, Coaxial, Automotive – Features Alligator Clips & RJ11 Plug

FIND WIRES QUICKLY AND ACCURATELY – Detect wires in a range of applications including buried wires (including single strand, broken wires, etc.) Not meant for live electrical wires. Suitable for Electrical wires, Landlines, Coaxial cables, Automotive cables etc…

SAVE TIME AND BE SAFE – Thanks to the Tone signal you will track your cable quickly and you don’t have to take the risk of not knowing exactly where your wires are located (Use only one alligator clip in Tone Mode)

FLEXIBLE USAGE – Thanks to the CONT mode you can check for short and open circuits, and the RJ11 connector lets you test telephone systems easily (Use both Alligator clips in Continued Mode)

ADJUSTABLE – Adjustable sensitivity for differentiating wires in close proximity and avoid false detection

NO RISK – One-year warranty and friendly customer service from seller TrueToSource!

CECOMINOD044744, 0767654080108, 767654080108

This Wire Tracer and Circuit Tester – including a sender/tone generator and a detector – is designed to identify and trace wires or cables without damaging the insulation.Note: Requires 2 9V batteries (not included)Use as a Wire TracerConnect only one of the alligator clips of the tone generator to your wire and use the probe to follow the wire along, or ID it at the other end. Use the probe?s volume control to adjust sensitivity. The audible tone will increase in volume as the probe gets closer to the wire. You can even use it totrace a single wire. Find broken wires buried in the ground or in walls. (Detection limit will vary depending on material between wire and probe. Swap tone generator for a more powerful signal source as needed.)Use as Circuit TesterConnect two alligator clips to the ends of the wire to check if resistance exists. If yes, the wire could be a short or open circuit. You can then use the Wire Tracer function to locate the problem.Telephone line maintenanceFor telephone lines, the Wire Tracer and Circuit Tester can identify Tip and Ring lines and determine the status of the line – clear, busy, or ringing – making it more convenient to maintain telephone lines.Specifications- Maximum length of cable tested: Allows for sending tone up to 328 feet / 100 m- Frequency: 1.1 to 1.4 kHz output for Sender; detects above 30 Hz for Detector- Power: 2 x 9V batteries (not included)- Dimensions and Weight: Sender: 2.8 x 2.6 x 1.2 inch / 7 x 6.5 x 3 cm ; 3 oz / 85g; Detector: 8.5 x 2 x 1.4 inch / 21.5 x 5 x 3.5 cm; 3.3 oz / 95gNote: Do NOT connect to a live circuit. Detector probe can be used with live circuits but should NOT be allowed to touch a live wire in any circumstance.Packaging ContentsDetector, sender with RJ-11 plug and 2 alligator clips, manual (batteries not included)

Leave a Reply